Back to Training Courses

Blown Film Training Course

 

Two Blown Film Training Courses are offered by PolyTech Consultants, an Intermediate Two-day course and an Advanced Four-day course, both of which follow the basic syllabus below, but with different emphases on the different sections, depending on your requirements :

 

1. Introduction to the Blown Film Process
2. Safety
3. Polymers: Types and Structures
4. Physical & Flow Properties of Polymers
5. Basic Extruder Design
6. Temperature Control of the Extruder
7. The Melting Mechanism and Screw Optimisation
8. Melt Filtration and Die Design
9. Film Cooling, Collapsing and Winding
10. Polymers used in Film Blowing
11. Surface Treatment - Corona Discharge
12. The Effect of Processing on Film Properties
13. Quality Control
14. Production Procedures and Troubleshooting
    

The above syllabus can be modified to suit your company's requirements.  Ideally, the maximum number of participants should not be greater than 8.

Copyright © PolyTech Consultants 1999-2002

---